彩库宝典app

1. Cut all of four packing belts, then remove the top as the drawing 1.

2. Remove the top.

3. Remove the infront, back, left, right board.

3.1  Loosen and take off 3 screws from the back board as the drawing 2 .

3.2   Drag out four 4 and take it out of the bottom as the drawing 3.

4.  Remove the three package Cushion as drawing 4 and Drawing 5.

5.  Take the packaged bench, leg, pedal from the cartons as drawing 6 and drawing 7. 

6. Install the right and back leg as drawing 8 and drawing 9.

7.  Insert a Foam pad in 45 mm thickness into the key bed of piano infront as drawing 10, turn it carefully, let the right, back leg standing on the floor, use the suitable high and solid upholder(or bench), install the left leg, then remove the upholder, make the three leg of the piano standing on the floor. At last, remove the protection package of fallboard and piano cover.as drawing 10 and drawing 11.

8.  Install the pedals as following statement.

8.1  Take the caster cup and remove the package of pedal, drag out two inclined stick from the key bed as drawing 12, and switch it point the front as drawing 13.

8.2  Take the two locative pedal capstan slot into the location hole as drawing 14, in the meantime, take the incline stick slot into the pedal box to the relative incline hole. At last, wreck the pedal capstan locate in the key bed.

      

9.  Detach the stick which roped the hammer shanks.

9.1  Open the key top upright and take it off as drawing 15

9.2 See the a hexagonal screw on the pin block on each side of the action from inside, wrench the screw under 2-3 mm at clockwise side as drawing 16

9.3  Detach the stick roped on the hammer shank.

①    Loosen out the screws which fixing key block on both sides of the keyboard as drawing 17. In order not to break the wooden pin on both bottoms of key block and lock rail, the key block should be brought out in straight upward direction. Then take out lock rail.

②    Catch both action brackets by hands and pull the keyboard and the action out. A wood stick roped on the hammer shanks can be seen. Loosen the ropes and take the stick out.

③   Reset keyboard and action until they can not move on, in the meantime, keep both edges

   of keyboard and key bed parallel. Do not press any key during resetting.

④   Re-install lock rail, key block, and tighten the bolt of the key block step by step.

9.4  Re-install the fall board. Now the piano is ready to be played.

 

 

 The information contained in this document is subject to change without notice.